Please choose a tip size from the drop down box below.
All tip sizes are in inches use the conversion chart on this page to see the size in millimeters.
This engraving tool has a profile that will allow you to engrave or mill deeper into your part or mold without losing tomuch detail. It has a single lip cutting edge that cuts very clean. This tool is a good choice when fine detail is needed. It works well in plastic and other soft materials.
Included angle = 30 degrees
Side angle = 15 degrees
Cut Length Inches = .2100
Cut Length MM = 5.5
Shank Diameter = 1/8 (3.175mm)
Tool Length = 1-1/2 (38mm)