SRF2-500C - 2 Flute UpCut Bit (1/2) - 1/2" x 3" - 1"LOC

SRF2-500C - 2 Flute UpCut Bit (1/2) - 1/2" x 3" - 1"LOC


$45.00


Part#: SRF2-500C

Product Details

1/2 x 3” Solid Carbide Flat (SQ) End Mill with a .500 (1/2") cutting tip and a 1 inch length of cut. Perfect for milling plastic, wood and aluminum.These tools are coated with a proprietary high performance *Astra coating* that allows higher speed & feed rates as well as extended tool life & increased lubricity in abrasive material.  Our tools are all Made in the USA with the finest carbide available.

Flat (SQ) End Mills have a square end for milling square slots, pockets, and edges. All are center cutting, allowing plunge cuts into a surface.

 

Tip Size Inches: .500
Tip Size MM: 12.7
Length of Cut/Inches: 1.000
Length of Cut/MM: 25.04
Shank Diameter: .500 (12.7mm)
Tool Length: 3 inches (75mm)

 

This data serves as a general guidance only.
Soft/Hard Woods/ Plywoods - Spindle Speed- RPM: 18K  - Feed Rate - IPM : 150-200" - Ramp Down: 75-100
MDF / Laminate / Melamine - Spindle Speed- RPM: 18K  - Feed Rate - IPM : 200-250"  - Ramp Down: 125-150
Copyright © 2020 Bits & Bits.