Engraving Tool 30 deg - 1/8 x 1-1/2"

Engraving Tool 30 deg - 1/8 x 1-1/2"

$10.50

Make Selection

 

Part#: 815-HF30

Product Details

This engraving tool has a 30 degree angle that will allow you to engrave or mill deeper into your part or mold without losing too much detail. It has a single lip cutting edge that cuts very clean. This tool is a good choice when fine detail is needed. It works well in plastic and other soft materials. Solid Carbide made in USA by Bits & Bits Company.

Please choose a tip size from the drop down box.

Included angle = 30 degrees
Side angle = 15 degrees
Cut Length Inches = .2100
Cut Length MM = 5.5
Shank Diameter = 1/8  (3.175mm)

Tool Length =  1-1/2  (38mm)

Copyright © 2018 Bits & Bits.