MENU
Cad Cam Milling Tools
Miniature End Mills
Engraving Tools
Plotter Blades
Profile Tool 30 degree 1/8\" x 1-1/2\"
  • Profile Tool 30 degree 1/8" x 1-1/2"
Profile tools will allow you to engrave or mill deeper into your part or mold without losing too much detail. It has a single lip cutting edge that cuts very clean.  This tool is a good choice when fine detail is needed. Please specify tip size when ordering.

Included angle = 30 degrees

 

Side angle = 15 degrees
Cut Length Inches = .2100
Cut Length MM = 5.5

Shank Diameter = 1/8  (3.175mm)

Tool Length =  1-1/2  (38mm)


Please choose a tip size from the drop down box below.
All tip sizes are in inches use the conversion chart on this page to see the size in millimeters.

 

Profile Tool 30 degree 1/8" x 1-1/2"

Part Number: 815-PR30

Profile tools will allow you to engrave or mill deeper into your part or mold without losing too much detail. It has a single lip cutting edge that cuts very clean.  This tool is a good choice when fine detail is needed. Please specify tip size when ordering. Included angle = 30 degrees   Side angle = 15 degrees Cut Length Inches = .2100 Cut Length MM = 5.5 Shank Diameter = 1/8  (3.175mm) Tool Length =  1-1/2  (38mm) Please choose a tip size from the drop down box below. All tip sizes are in inches use the conversion chart on this page to see the...

$9.50