Profile tools will allow you to engrave or mill deeper into your part or mold without losing too much detail. It has a single lip cutting edge that cuts very clean. This tool is a good choice when fine detail is needed. Please specify tip size when ordering.
Included angle = 30 degrees
Side angle = 15 degrees
Cut Length Inches = .2100
Cut Length MM = 5.5
Shank Diameter = 1/8 (3.175mm)
Tool Length = 1-1/2 (38mm)
Please choose a tip size from the drop down box below.
All tip sizes are in inches use the conversion chart on this page to see the size in millimeters.