45 deg 1/4 x 2-1/2 Carbide Engraving Router Bit
This is a solid carbide engraving router bit with 45 degree included angle (22.5 degrees per side). Our 45 deg 1/4 x 2-1/2 engraving tool is a very popular choice for engraving small detail on wood or plastic and even aluminum. It will cut a 45 degree angle into your material. These tools are coated with a proprietary HP-Astra™ High Performance coating that allows higher speed & feed rates as well as extended tool life & increased lubricity in abrasive material. Made in the USA
Included angle = 45 degrees
Side angle = 22.5 degrees
Shank Diameter = 1/4 (6.35mm)
Tool Length = 2-1/2 inches
This data serves as a general guidance only.
Soft Woods/ Hard Woods/Plastics/Aluminum
Spindle Speed- RPM: 16-18K
Feed Rate - IPM : 40-110"
